| COMPLETE
SETUP |
| MYO-01 |
Small vessel (200 µm) myograph bath system to measure
small vessel contraction, includes one operation base plate, one water-jacketed chamber,
one force transducer (FSG-01/50), one two-plane maniuplator (AM-02), one pair of tungsten
wire holders, bridge amplifier (SG), tubing, buffer, carbogen connection, and starter
kit: tungsten wire (100 µm x 3 meters and 50 µm x 3 meters), three glass covers,
silicone grease, screws and screwdriver |
| COMPONENTS/SPARE
PARTS |
| FSG-01/50 |
Force transducer |
| SG |
Bridge amplifier for measurement of contractile force
(strain gauge) |
| -- |
Dual-plane manipulator |
| -- |
Tungsten wire, 100 µm x 3 meters |
| -- |
Tungsten wire, 50 µm x 3 meters |
| -- |
Fixed holder with screws |
| -- |
Angled holder with screws |
| -- |
Screwdriver set, three pieces |
| -- |
Tubing set (5-pack) |
| -- |
Transducer clip (3-pack) |
| -- |
Oxygen pipe (10-pack) |
| -- |
Glass cover (10-pack) |
| OPTIONAL
DEVICES |
| -- |
Low-flow pump |
| -- |
Circulating water bath |
| COMPLETE
SYSTEM FOR SMALL VESSEL REACTIVITY MEASUREMENT |
| MYO-01 |
Small vessel (200 µm) myograph bath system to measure
small vessel contraction, includes one operation base plate, one water-jacketed chamber,
one force transducer (FSG-01/50), one two-plane maniuplator (AM-02), one pair of tungsten
wire holders, bridge amplifier (SGM), tubing, buffer, carbogen connection, and starter
kit: tungsten wire (100 µm x 3 meters and 50 µm x 3 meters), three glass covers,
silicone grease, screws and screwdriver |
| ST-01I |
Single-channel electronic stimulator with isolator,
includes MCU stimulator and ISO-100 isolator |
| RPW-04 |
Rack and power supply for four amplifiers (110V/50Hz) |
| ISOSYS |
Software and hardware system for data acquisition and
analysis of isolated tissue investigation, includes 8-channel interface card (ISY-100),
interface cable, computer interface board (ISY-101), rack and power supply (RPW-04),
Pentium computer with monitor and mouse |
|
